In pedoffice there are currently interfaces to the following pressure measurement systems:

• Currex
• Medilogic
• Novel
• RS Scan (Beta)

Choose at „Device“ Currex an click on . The FootWork Software will be started and the following customer data will be transfered:

• First Name
• Last Name
• Date of birth
• sex

Depending on the FootWork version, the customer is already selected after the start. If the customer is not selected, you need to select the customer name and start a dynamic measurement. After saving the measurement, export it as an .adp file and close the FootWork software. The pedoffice should have recognized the exported measurement. This can be recognized by the corresponding entries in the fields „file left foot“ and „file right foot“.

The pedoffice only recognizes newly exported measurements, performing a measurement is not necessary. The last name of the customer in FootWork must match the one in pedoffice. Only dynamic measurements can be exported as .apd file in FootWork.

For the configuration please contact the pedcad service.

Select at device Medilogic and click on the button . The Medilogic software will start. Perform a measurement and export it via Data ⇒ Export… ⇒ Export pedcad Fig. 2 and close the Medilogic software.

The pedoffice should recognize the exported measurement. This can be recognized by the corresponding entries in the fields „file left foot“and „file right foot“.

The pedoffice just recognizes newly exported measurements, performing a measurement is not necessary.

For the configuration please contact the pedcad service.

Wählen Sie unter Gerät Novel aus und klicken sie anschließend auf . Die Novel Software wird gestartet. Führen Sie eine Messung durch und exportieren Sie diese.

Das pedoffice sollte die exportierte Messung erkannt haben. Diese ist an den entsprechenden Einträgen in den Feldern Datei - Links und Datei - Rechts zu erkennen.

Für die Konfiguration wenden Sie sich bitte an den pedcad Service(service@pedcad.de).

Diese Schnittstelle befindet sich noch in der Testphase(Beta). Für weitere Auskünfte und die Konfiguration wenden Sie sich bitte an den pedcad Service(service@pedcad.de).